NETGEAR CG814WG V3 - Manual (Page 44)

Wireless Cable Modem Gateway CG814WG v3 Reference Manual
4-6 Managing Your Network
v1.0, June 2007
Resetting to Factory Default Settings
You can erase the gateway configuration and reset it to the factory default settings. The factory
default settings are shown in See
“Factory Default Settings” in Appendix A .
On the Backup Settings screen, select Yes for Restore Factory Defaults and then click Apply.
The gateway reboots automatically. The gateway’s password will be password, the LAN IP
address will be 192.168.0.1, and the gateway’s DHCP client will be enabled.
Event Log
The gateway logs security-related events such as denied incoming service requests and hacker
probes. You can enable e-mail notification to receive these logs in an e-mail message.
For information about e-mail notifications, see “Logs” in Chapter 3 .
Note: If you do not know the login password or IP address, you can use the reset
button on the rear panel of the gateway to restore the factory default settings.
Figure 4-6