Connecting to an ethernet, Connecting to an analog voice network, Analog voice module – Nx Networks 3000 User Manual
Page 25: Ethernet, Isdn module, Analog voice network
3000 Series User Guide
11
Connecting to an Ethernet
To connect your 3000 Series to an Ethernet network,
1. Connect one end of an Ethernet 10BaseT (UTP) straight-through cable to
the ETH connector in the 3000 Series fixed slot.
2. Connect the other end of the cable to an Ethernet 10BaseT hub.
Connecting to an Analog Voice Network
Note: You cannot connect the analog voice module directly to the external
network.
The type of cable you use depends on the interface type that the equipment
you connect to supports. For compliance with applicable regulations, you
need to use shielded cables.
To connect your 3000 Series to your PBX or voice or fax telephone
equipment,
1. Connect one end of the cable to the RJ-45 connector on the 3000 Series.
2. Connect the other end of the cable to the PBX, telephone, or fax device.
Ethernet Hub
PC
3000 Series
PC
Printer
3000 Series
VOIC
E
OICE
V1
V1
D1
D1
D2
D2
D3
D3
ETH
ETH
V2
V2
V3
V3
V4
V4
DATA
ALM
ALM
OK
OK
PWR
PWR