N-Tron Ntron 7014FX2 User Manual
Page 111
6/28/2007 page 111 of 145
Set Flow Control
Command Name
port set flowcontrol
Description
Enable or Disable flow control (typically refers to 100Base). When
enabled a pause frame will be sent to help control the flow.
Syntax
port set flowcontrol <port-no>
Parameters
port-no
port number (1 ~ 12)
enable | disable
Flow Control enable or disable
Examples
N-TRON/Admin#[1]> port set flowcontrol 6 enable
NOTES
Check whether port-no is in the valid range. (1 ~ 12)
Set Name
Command Name
port set name
Description
Changes the name of the port. This change will only be visible in the CLI.
Syntax
port set name <port-no>
Parameters
port-no
port number (1 ~ 14)
name
A string that describes the port
Examples
N-TRON/Admin#[1]> port set name 6 waterplant
NOTES
This will be reset if you change a slot configuration.
Set PVID
Command Name
port set pvid
Description
Set a port’s VLAN-ID.
Syntax
port set pvid <port-no>
Parameters
port-no
port number (1 ~ 14)
pvid-number
The VLAN-ID number of the VLAN that this port will be a member of
Examples
N-TRON/Admin#[1]> port set pvid 6 2
NOTES
A port can be a member to several VLANs, but can only have one PVID
Set Backpressure
Command Name
port set backpressure
Description
Enables or disables backpressure on a given port. This is normally used on
10Base setups and is a controlled by the hardware.
Syntax
port set backpressure <port-no>
Parameters
port-no
port number (1 ~ 12)
enable | disable
Backpressure enable or disable
Examples
N-TRON/Admin#[1]> port set backpressure 6 enable
NOTES
Check whether port-no is in the valid range. (1 ~ 12)
Set Intruderstate
Command Name
port set intruderstate
Description
Enables or Disables the intruder log.
Syntax
port set intruderstate
Parameters
enable | disable
Enable or disable the intruder log
Examples
N-TRON/Admin#[1]> port set intruderstate enable
NOTES
This must be enabled for the intruder log to log anything.