Nikon LS8000 - Manual (Page 72)

62
Using Nikon Scan
This example illustrates how to scan 35-mm film using the FH-835S film holder.
Using Nikon scan for the First Time
The first time you run Nikon Scan, the status LED will emit five series of rapid blinks (each of about three
seconds duration) when you first insert holder with the scanner on or if you start Nikon Scan for the first
time with the scanner on and a holder in place. This does not indicate an error. Do not eject the holder. If
you ejected the holder while the status LED was blinking, turn the scanner off and then on again and
restart Nikon Scan.