National Instruments SCXI-1161 User Manual
Page 58
Index
I-2
© National Instruments Corporation
flyback voltage. See contact protection for
inductive load connections.
FTP support, C-1
H
hardware installation, 2-9
I
inductive load connections, contact protection
for. See contact protection for inductive load
connections.
installation
hardware, 2-9
unpacking the SCXI-1161, 1-6
INTR* signal, SCXIbus to SCXI-1161 pin
equivalencies (table), 3-8
J
jumpers
overview of use, 2-5
parts locator diagram, 2-2
jumpers W1 and W2
configuration (table), 2-7
overview of use, 2-5 to 2-6
using the jumpers, 2-6 to 2-7
jumpers W3, W4, and W5
configuration of DIO and MIO boards
(table), 2-8
overview of use, 2-5
using the jumpers, 2-8
L
LabVIEW software, 1-2
LabWindows/CVI software, 1-2
M
MIO boards, jumper W3, W4, and W5
configuration (table), 2-8
MISO signal
jumper W1 and W2 connections,
2-5 to 2-7
SCXIbus to SCXI-1161 pin equivalencies
(table), 3-8
module configuration. See configuration.
MOSI signal, SCXIbus to SCXI-1161 pin
equivalencies (table), 3-8
N
NI-DAQ driver software, 1-3 to 1-4
O
operating environment specifications, A-2
operation of SCXI-1161. See theory of
operation.
P
parts locator diagram, 2-2
physical specifications, A-2
R
rear signal connector, 3-4 to 3-8
digital I/O connections, 3-7
pin assignments (figure), 3-5
SCXIbus to SCXI-1161 pin equivalencies
(table), 3-8
signal descriptions (table), 3-6 to 3-7
register-level programming, 1-4
relay channels, 4-5