National Instruments VXI-MIO Series - Manual (Page 24)

Chapter 2 Configuration and Installation
 National Instruments Corporation 2-5 VXI-MIO Series User Manual
Figure 2-3. VXI-MIO-64XE-10 Logical Address Selection
SIMM Size
Each VXI-MIO module can accommodate up to two 1.35 in. DRAM
SIMMs. Table 2-1 lists the SIMMS you can use. You can use 32-bit or
36-bit SIMMS since DRAM parity is not required. Because the
VXI-MIO module supports only one organization at a time, all SIMMs
installed must be of the same type. Use bank 0 first when installing the
SIMMs, so that you can install up to 64 MB. The VXI-MIO module
supports DRAM speeds of 80 ns or faster.
Use switch S3 to select the size of each SIMM. The SIMM sockets are
accessible only by removing the component right side cover, but S3 is
P1 Connector U73 VXI-MIO-64XE-10 Module
1 2 3 4 5 6 7 8
Logical Address
Switch
Push up for logic 1
Push down for logic 0
a. Switch Set to Logical Address 2 (Default)
1 2 3 4 5 6 7 8
Logical Address
Switch
Push up for logic 1
Push down for logic 0
b. Switch Set to Logical Address 192
LSB MSB
MSB LSB
P1 Connector U73 VXI-MIO-64XE-10 Module