beautypg.com

Installation, Using optional stand/mounts, Mounting location – NEC 42XP10 User Manual

Page 9

background image

English

English-6

Using Optional Stand/Mounts

An optional stand or mounting apparatus can be installed .

When stand or mounting apparatus is to be installed
while the unit is face-down (Figure 1), be sure to lay the
protective sheet (the foam sheet that the unit was wrapped
in) underneath the unit on order to prevent damage to the
screen.

Th

is unit must be used with a stand or some type of

mounting apparatus. Th

is unit is not designed for use

without additional support.

For correct Installation and Mounting it is
recommended to use a trained, authorized dealer.

Failure to follow correct mounting procedures could
result in dame to the unit or to the installer.

Product warranty does not cover damage caused by
improper installation.

CAUTION:

To install, follow those instructions included with the
stand or mounting apparatus. Use only those devices
recommended by the manufacturer.

Make sure to install stand or mounting apparatus to the
unit while on a surface that is strong and stable enough
to support the weight of the unit, such as a fl oor or
sturdy table.

Use the specifi ed clasps for installation.

Take necessary steps to prevent the unit from tipping or
falling.

Mounting Location

Th

e ceiling and wall must be strong enough to support the

monitor and mounting accessories.

DO NOT install in locations where a door or gate can hit
the unit.

DO NOT install in areas where the unit will be subjected
to strong vibrations and dust.

DO NOT install near where the main power supply
enters the building.

DO NOT install in where people can easily grab and
hang onto the unit or the mounting apparatus.

When mounting in an enclosure or in a recessed area, as
in a wall, leave at least 2 inches (50mm) of space between
the monitor and the wall for proper ventilation (Figure 2).

Allow adequate ventilation or provide air conditioning
around the monitor, so that heat can properly dissipate
away from the unit and mounting apparatus.

50mm (2")

50mm (2")

50mm (2")

50mm (2")

50mm (2")

Installation

Figure 2

Figure 1

Table

Optional table top stand

Protective Sheet

This manual is related to the following products: