NEC 42XP10 - Manual (Page 28)

English-25
Operation
- continued
REPEAT TIMER
Th e Repeat Timer allows the display to alternate between
inputs at user-determined intervals.
For example the display can be programmed to show the
signal from "VIDEO1" for 10 minutes and then switch to
showing the signal from the DVI input for 10 minutes.
To set the Repeat Timer select "REPEAT" in the Timer
menu, then press the SET button. To enter the REPEAT
TIMER OSD screen. Th
en make the desired settings.
STATE Settings
Th
ere are 4 possible state settings to use. When all four
STATES are set to "ON, the repeat timer schedules will
operate consecutively (State1, State2, State3, State4, State1,
State2, State3...).
When a STATE setting is set to OFF, i.e. STATE1-ON,
STATE2-ON, STATE3-OFF, STATE4-ON, the repeat timer
schedules use all but STATE3 (State1, State2, State4, State1,
State2...).
Repeat Timer activates when the OSD menu is exited.
For SINGLE display confi gurations
WORK TIME: Set the time duration of the schedule. Time
range is from 1 minute to 24 hours.
INPUT MODE: Choose the signal that will be used.
MULTI settings
MODE: Select the input mode to be displayed as “SINGLE”,
“S BY S 1, 2R or 2L” or “PICTURE IN PICTURE MODE
(BTM LFT~TOP LFT)”.
WORK TIME: Set the time duration of the schedule. Time
range is from 1 minute to 24 hours.
INPUT MODE: Choose the signal that will be used.
Select “MAIN” or “SUB” for “PICTURE IN PICTURE
MODE (BTM LFT~TOP LFT)” and “LEFT” or “RIGHT” for
“S BY S1, 2R or 2L”.
Only one signal is selected for “SINGLE”.