Resetting the lamp hours counter – NEC NP4001/NP4000 User Manual
Page 121
6. Maintenance
109
Resetting the Lamp Hours Counter
After replacing the lamp(s), the lamp hour counter(s) should be reset to zero. Refer to
the following guide:
1.
Press the Menu button on the
OSD control panel or Re-
mote Control to open the
Main menu.
2.
Press the ▲or▼ button to
move to the Reset menu and
press Enter.
3.
The Reset menu is displayed.
Select Clear Lamp 1 or
Clear Lamp 2 as required
using ▲or▼ and press En-
ter.
4.
A confirmation box is dis-
played. Select OK using
◄ or ► and press Enter to
reset the selected Lamp hours
to zero.
See also other documents in the category NEC Projectors:
- LT280 (40 pages)
- XT9000 (54 pages)
- XL-3500 (81 pages)
- LT260K (152 pages)
- LT265 (145 pages)
- M260W (155 pages)
- NP310 (114 pages)
- MT840 (42 pages)
- GT2150 (74 pages)
- MT 820 (44 pages)
- MT1056 (55 pages)
- MT1056 (6 pages)
- MT820 (44 pages)
- Projector VT560 (15 pages)
- MultiSync MT600 (32 pages)
- NP115 (92 pages)
- LT150 (59 pages)
- MM2000B (1 page)
- MT830 (48 pages)
- MT1030+ (55 pages)
- MT850 (56 pages)
- NP300 (6 pages)
- XT4100 (52 pages)
- NP41 (100 pages)
- VT440 (2 pages)
- WT600 (76 pages)
- NP2250 (183 pages)
- MultiSync GT2000 (87 pages)
- MT1055 (7 pages)
- LT170 (45 pages)
- NP2000 (9 pages)
- NP3250 (9 pages)
- MT1060 (70 pages)
- MT1075/MT1065 (69 pages)
- LT75Z (40 pages)
- MT1035 (53 pages)
- NP3151W (172 pages)
- NP4000 (2 pages)
- LT260 (149 pages)
- MT1045 (42 pages)
- MultiSync XG135LC (38 pages)
- WT615 (159 pages)
- LT157 (61 pages)
- NP100/200 (5 pages)
- NPSTWM (8 pages)