National Instruments 6008 - Manual (Page 7)

© National Instruments Corporation 7 NI USB-6008/6009 User Guide and Specifications
Setting Up Hardware
Complete the following steps to set up the hardware:
1. Install combicon screw terminal blocks by inserting them into the
combicon jacks.
2. Figure 4 illustrates the signal labels that ship in the NI USB-6008/6009
kit. You can apply the signal labels to the screw terminal blocks for
easy signal identification.
Figure 4. NI USB-6008/6009 Signal Labels
3. Refer to Table 3 and Figures 4 and 5 for signal label orientation and
affix the provided signal labels to the screw terminal blocks. Until the
signal labels are applied, you can insert the screw terminal blocks into
either of the combicon jacks.
1 Terminal Number Labels (Use Both Together)
2 Digital I/O Label
3 Single-Ended Label (Use Either)
4 Differential Label (Use Either)
ANALOG DIGITAL
3
1
4
2