Nikon LS-2000 User Manual

Page 44

- 44 -

Using the Scanner: Using the SF-200 Slide Feeder

✔

Cautions

• Slides must be from 1.0 mm to 3.2 mm thick.

• Mounts with rough surfaces could cause the feeder to jam.

• Do not use mounts with peeling or burred edges, mounts to

which seals or labels have been affixed, or mounts with sharp
corners. Such mounts could jam the feeder or cause prob-
lems during scanning.

• Avoid slides with warped mounts. Warped slides may jam if

placed in the feeder as shown below.

• The feeder does not function equally well with all makes of

slide mount. Makes that have projecting parts or are not of
an even thickness may jam in the feeder.

• Do not load slides into the feeder with the longer side of the

aperture facing the scanner, as this could damage the film or
slide mount or cause the feeder to jam. Insert slides as
shown by the insertion guide sticker next to the feed maga-
zine (see illustration on page 43).

• Do not load slides in the feed magazine past the load mark,

as this may cause the feeder to jam.

• Do not move the scanner while scanning is in progress.

• Remove scanned slides from the ejection magazine before

the magazine is full. Continuing scanning when there is no
room left in the ejection magazine could jam the feeder.

• Do not remove the feeder while scanning is in progress.

• Before turning the scanner off or removing the feeder, make

sure that all slides have been removed from the magazine
and that the last slide to be fed has been ejected.