Nikon LS-2000 - Manual (Page 17)

- 17 - Setup
Setup
This chapter explains how to set up your scanner and connect
it to a computer. Before using your scanner, you will need to
complete the following steps:
• select a suitable location for the scanner
• remove the transport locking screws
• connect the power and SCSI cables
• set the SCSI ID
These steps are described in the sections that follow.
Installation
Before connecting the LS-2000 to your computer, choose a flat,
stable location for it, free from vibration and dust. Do not
install your scanner where:
• it would be exposed to direct or
reflected sunlight
• it would be subject to condensa-
tion or drastic changes in tempera-
ture
• the temperature exceeds 35ºC
(95ºF) or falls below 10ºC (50ºF)
• other objects might block the
scanner’s vents
• it would be subject to radio interference from other elec-
tronic devices