Nikon LS-2000 - Manual (Page 24)

- 24 - Setup: Connecting the SCSI Cable
Connect a second SCSI cable to the other of the two connec-
tors on the rear of the scanner, then connect the other end of
the cable to another SCSI device. Confirm that the last device
in the chain is terminated.
Other SCSI device
Terminator
MADE IN JAPAN 1 0 0 0 9 8
S C S I S C S I
SCSI NB TERMINATOR
OFF ON 6 5 4 3 2 1 0 7
100–240V~
0.3–0.2A
50/60 Hz
Note: If the last device in the chain has an unused SCSI connec-
tor, a separate terminator should be attached to it, even if the
device is connected to the SCSI chain using a through terminator.
When the scanner is between other devices
Set the terminator switch on the rear of the scanner to OFF.
TERMINATOR
OFF ON
Connect one end of the SCSI cable to either of the connectors
on the rear of the scanner, then connect the other end to one
of the devices in the chain.
MADE IN JAPAN
100098
SCSI
SCSI
SCSI NB
TERMINATOR OFF
ON
6 5
4
3 2 1
0
7
✔
Caution: Do not touch the connector pins with your fingers
or with metal objects, as this could result in static electricity dam-
aging one or more of the devices in the SCSI chain.