Nikon LS-2000 - Manual (Page 19)

- 19 - Setup: Installation
When using the optional SF-200 slide feeder Once the scanner is installed, slide the front cover open. Using
a coin, remove the transport locking screws from the adapter
slot and side panel and screw them into the holes provided on
the rear panel. The adapter slot contains a guard to prevent
the transport screw from falling into the scan mechanism when
the transport screw is removed. After removing the transport
screw from the adapter slot and screwing it into one of the
holes on the rear of the scanner, remove the guard and store it
in a safe place.
✔
Caution: Never turn the scanner on with the locking screws
in place. Turning the power on in these circumstances could
damage the scanner.
Note: Replace the locking screws and guard when transporting
the scanner (see “Maintenance: Transporting the Scanner,”
below).
Transport locking screws
MADE IN JAPAN
100098
SCSI
SCSI
SCSI NB
TERMINATOR OFF
ON
6 5
4
3 2 1
0
7
100–240V~ 0.3–0.2A 50/60 Hz
Holes for locking screws
Guard
Coin