NEC XT5000 - Manual (Page 26)

E – 26
REMOTE 1 Connector
This connector is used for either connecting the ISS-6020/ISS-6020G Switcher or a third party external control device. When
the Switcher is used, connect it with the optional control cable (15-15 pin; 50 ft./16m; CTL-6010) to this connector.
When used with the Switcher.
Pin No. FUNCTION
1, 2, 6 and 7 Sending and receiving data when the Switcher is used.
9 Identifying the Projector
15 Ground
Others Used inside the Projector. Normally set to OPEN.
When using with the Switcher ISS-6020/ISS-6020G, connect no. 1,2,6,7,9 and15 pins of the projector to the same no. pins of
the switcher as shown below.
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Pin Configuration of Optional CTL-6010 Cable
REMOTE 1 connector of the Switcher
mini D-sub 15 pin (female) REMOTE 1 connector of the Projector
mini D-sub 15 pin (female)
Shield (frame ground)
Pins without a number are open.
1
6
7
2
9
15
6
7
9
1
2
15