Newcon Optik NVS 6 User Manual
Page 31
30
NOTE
Before using the NVS 6 for flight operations, be sure to check
out the system's operation. Perform the checkout under darkened
conditions.
Use the following operating procedures for check out. If a failure
occurs, refer to the troubleshooting procedures in Chapter 3,
Section II. If the problem persists, the system must be returned to
the maintainer.
Make sure the batteries are installed as described in paragraph
2.3.1. Remove the lens caps. Turn the power switch initially to
one of the ON position. A green glow will appear in each
eyepiece (after a slight delay).
NOTE
If a red light appears at the base of the NVS 6 mount, the
batteries in that compartment are low and need to be replaced.
Switch to the other battery compartment and make sure those
batteries are good.
Turn the vertical adjustment knob (see Fig.2-7) to center the
eyepieces in from of your eyes. Minor readjustment may be
needed after adjusting the tilt lever.