Nortel Networks 1220 - Manual (Page 119)

Operating your IP Phone 1220
119
Managing multiparty calls
Use the following features to enable multiparty conversations:
• “Using Call Join” on page 119
• “Setting up a Conference Call” on page 119
• “Using Conferee Selectable Display” on page 120
• “Using Group Call” on page 122
Using Call Join
Use the Call Join feature to connect a new caller to an active call. This
connection creates a conference (conversation involving more than two
parties) between the two callers and yourself.
Setting up a Conference Call
Use the Conference feature to initiate a conference call for a group of
three to six people including yourself. The maximum number of people
supported in a conference call depends on the IP Phone configuration.
1. To connect a call on hold to your current
call, press the
Conf soft key.
2. Press the line key of the caller you want
to connect to your current call.
3. Press the Conf soft key again to join the
person on hold to your conversation.
1. During a call, press the Conference key
to place the party on hold.
You hear a dial tone.
Conf
Conf
Conf