National Instruments SCB-68 - Manual (Page 16)

Chapter 1 Introduction
SCB-68 Shielded Connector Block User Manual 1-6 ni.com
Figure 1-2 shows how to use a 68-pin cable to connect the SCB-68 to a
68-pin DAQ device.
Figure 1-2. Connecting a 68-Pin DAQ Device to an SCB-68
Using 100-Pin Cables
You can use the SH1006868 cable assembly to connect two SCB-68
connector blocks to a 100-pin DAQ device. The SH1006868 is Y-shaped,
with a 100-pin male connector on one end and two 68-pin female
connectors on the opposite end. The DAQ device connects to the 100-pin
cable connector, and an SCB-68 can connect to each 68-pin cable
connector. Figure 1-3 shows how use the SH1006868 to cable a 100-pin
DAQ device to two SCB-68 devices.
1 68-Pin Cable Assembly
2 68-Pin DAQ Device
3 68-Pin I/O Connector
4 68-Pin I/O Connector
5 SCB-68 Connector Block
2 3
1
5 4