Nikon Coolpix 300 - Manual (Page 108)

94 Troubleshooting : General Problems
Nikon View displays a “Module has no sources” error when
you attempt to display the camera's data files on your com-
puter
Checklist:
• Is the camera correctly connected to the computer?
Connect the camera to your computer’s serial port or SCSI chain as
described in “Connections.” If you are using an SCSI connection, be
sure that the device number you have chosen for the camera is not the
same as that assigned other SCSI devices, that
ON has been chosen as
the camera’s TERMINATOR setting, and that one of the devices in the
chain is providing termination power. If you are using a notebook
computer, check its documentation to determine whether it requires an
additional external terminator at the computer’s end of the SCSI
chain. In the event that you are using a serial connection, check to be
sure that the data transfer rate you have chosen is supported by your
computer, and that the computer’s port settings are “8-bit, no parity,
one stop bit.”
• Is Nikon View properly installed on your computer?
Consult the documentation provided with the software.