Nikon Coolpix 300 - Manual (Page 102)

88 Troubleshooting : General Problems
The touch-panel display does not respond when touched by
the stylus
Over time, the areas of the touch panel which respond to the stylus may
begin to differ from the positions shown on the display. The display can be
re-calibrated by following the steps listed below.
1. Turn the camera on while touching the display with the stylus (you will
need to keep the stylus in place for more than three seconds after the
camera is turned on). The following screen will appear in the display.
Note: If the camera is turned off when the calibration screen is displayed,
the screen will appear again when the camera is next turned on.
Red square