NEC PlasmaSync 3300 - Manual (Page 9)

G RGB 2
R, G, B, H/CS and V IN (BNC)..... These are analog RGB input terminals.
Connect external components with R, G, B, H/CS, and V output terminals to
these analog RGB input terminals. Be sure that the RGB connection cable is
correctly attached to the corresponding terminals.
R, G, B, H/CS and V THROUGH OUT (BNC)..... Connect to a second monitor's
RGB inputs to relay the RGB signal inputs at R, G, B, H/CS and V IN.
75
Ω
/HIGH Impedance Select Switchs for RGB and H/CS&V..... Set to "75
Ω
"
during normal operation. In multiple connections using R, G, B, H/CS and V
IN and OUT terminals, set to "HIGH" on all but the last monitor. Set to "75 Ω "
on the last monitor only.
H External Speaker Terminals
+ RIGHT..... Connect RIGHT speaker positive wire here.
- RIGHT..... Connect RIGHT speaker negative wire here.
- LEFT..... Connect LEFT speaker negative wire here.
+ LEFT..... Connect LEFT speaker positive wire here.
I Internal Speaker Terminals
To enable the internal speakers, use the supplied speaker cables to con-
nect between the external speaker terminals H and here.
J AC Input
Connect the supplied power cord' s three-pin plug here.
G
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
H
I
9
10
J