NEC PlasmaSync 3300 - Manual (Page 6)

1 POWER .............................. Press to power the monitor on and off.
2 STANDBY /POWER ............ Lights green during normal operation.
Lights orange when the monitor is in standby
mode.
3 Remote Sensor Window ........ Receives infrared signal from the remote control
unit.
4 EXIT ......................................... Press to exit the OSM controls in the main menu.
Press to exit to the previous menu in a submenu.
5 PROCEED ................................ Press to access OSM. Press to proceed to the
selected menu choice (indicated by the arrow).
Press to move the arrow down to select one of
the choices.
6 RGB 2 ...................................... Press to select the RGB source that is connected
to the RGB 2 input terminals (BNC type).
7 RGB 1 ...................................... Press to select the RGB source that is connected
to the RGB 1 input terminal (mini D-SUB 15 pin
type).
Part Names and Functions
Front View
3 2 1
3
4
Indicator
○○
○
6 5
VIDEO 1/VIDEO 2/RGB 1/RGB 2/PROCEED/EXIT
○
○
○
○
○
4 9 8 7
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
8 VIDEO 2 ................................... Press to select the video source that is
connected to the VIDEO 2 input terminal
(BNC type or S-VIDEO 2 IN).
9 VIDEO 1 ................................... Press to select the video source that is
connected to the VIDEO 1 input terminal
(BNC type or S-VIDEO 1 IN).
NOTE: S-VIDEO IN terminals will take preference over VIDEO IN termi-
nals when the video source is connected to each terminal and VIDEO 1
or 2 selected.