NEC PlasmaSync 3300 - Manual (Page 10)

Remote Control Unit
1 POWER ON/OFF ................ Press POWER ON to turn the monitor on
when the STANDBY/POWER indicator is lit
orange.
Press POWER OFF to turn the monitor off
and the monitor will go into the standby condi-
tion.
2 VIDEO 1 .............................. Press to select reception of a conventional
component or S-connector component con-
nected to VIDEO 1 IN terminal.
3 VIDEO 2 .............................. Press to select reception of a conventional
component or S-connector component con-
nected to VIDEO 2 IN terminal.
4 RGB1 .................................. Press to select reception of a component
connected to RGB 1 IN terminal.
5 RGB 2 ................................. Press to select reception of a component
connected to RGB 2 IN terminal. MULTIMEDIA MONITOR RD-336E
ON
OFF
ON POWER OFF DEGAUSS
VIDEO1VIDEO2 RGB1 RGB2
WIDTH
HEIGHT
SIDE PIN
SCAN SELECT
POSITION/CONTROL
NORMAL RASTER CONTROL
RGB/VIDEO VIDEO
CONTRAST BRIGHT COLOR TINT SHARPNESS
NORMAL VISUAL CONTROL
VOLUME MUTE
EXIT PROCEED ON SCREEN
1
2
3
5
4
6
7
11
12
Raster Control
6 POSITION/CONTROL ........ Adjusts the vertical position of the image up
and down, and the horizontal position of the
image from left to right.
CONTROL ( . / , ) .............. Moves the bar in the , or . direction to in-
crease or decrease the adjustment in an
OSM submenu.
CONTROL( / ᮢ ) ............. Moves the arrow up or down to select one of
the controls.
( / ᮢ / ᮤ / ᮣ )
7 NORMAL ............................ This key resets the raster adjustment set-
tings of user changeable memory and recalls
the factory preset data.
NOTE: This can be done to only the signal having the factory preset data.
ᮢ
ᮢ