NEC PlasmaSync 3300 - Manual (Page 18)

External Speaker Connections
External speakers may be connected to the monitor to reproduce sound from
VIDEO 1, VIDEO 2, RGB 1 or RGB 2 signal sources.
External speakers may be connected directly to the EXTERNAL SPEAKERS
terminals or indirectly by connecting a stereo system amplifier to the audio
outputs.
CAUTION: Unplug the monitor and all connected components before con-
necting external speakers. Use only speakers with 8-ohm impedance and a
power output rating of 5 watts or more.
To connect external speakers directly to the monitor:
1. Strip the ends of the speaker wires.
2. Press down a button below the EXTERNAL SPEAKERS terminals, insert
the speaker wire and release the button to secure a speaker wire connec-
tion:
[a] Connect the right speaker (located at right side of the monitor when
viewed from the front) positive (+) wire to RIGHT +.
[b] Connect the right speaker negative (-) wire to RIGHT -.
[c] Connect the left speaker negative (-) wire to LEFT -.
[d ]Connect the left speaker positive wire (+) to LEFT +.
SPEAKER SELECT
INT EXT
RIGHT
{
|
{
|
4 ft.
120cm
4 ft.
120cm
LEFT RIGHT
To connect the monitor to stereo system speakers:
1. Connect L AUDIO output to the stereo amplifier L AUX input.
2. Connect R AUDIO output to the stereo amplifier R AUX input.
IMPORTANT: Do not connect speakers to both the monitor EXTERNAL
SPEAKERS terminals and to the stereo amplifier. This could damage both
the monitor and the speakers.
28
27
HJJKKKASDFFF
BNGGDFDFGHY
ZZXXC CCVDFVFF
ADFGRTRYT
ADFGRTRYT
SFGHHHJJ SFGHHHJJ
DFFGGGG
AFHUJTT
AFHUJTT
DFFGGGG
2Q 2Q
2Q 2Q
JGHDYSTEOYII DYASGHIROYUKIAIZAWA
THROUGH
OUT
IN
R
R L
LINE OR
AUX INPUT LINE OR
AUX INPUT
STEREO AMP
L (MONO)
VIDEO or RGB AUDIO L and R
outputs of PlasmaSync 3300
-
+
To enable the internal speakers, use the supplied speaker cables to con-
nect between the external speaker terminals and the internal speaker termi-
nals.