Operation, Light bulbs – NuTone NP50000 User Manual

Page 10

OPERATION

Controls
The hood is operated using the slide controls
under the bottom of the hood.
The light switch turns the lamps on and off.
The blower switch: makes it possible to
select the motor operating speed.
Position 0: motor off.
The pilot lamp lights up whenever the blower
is on.

HEAT SENTRY™
Your hood is equipped with a HEAT
SENTRY™ thermostat. This thermostat is a
device that will turn on or speed up the blower
if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to

HIGH speed.

2) If blower is ON at a lower speed setting -

it turns blower up to HIGH speed.

When the temperature level drops to normal,
the blower will return to its original setting.

WARNING
The HEAT SENTRY thermostat can start
the blower even if the hood is turned OFF.
When this occurs, it is impossible to turn
the blower OFF with its switch. If you must
stop the blower, do it from the main
electrical panel.

LIGHT BULBS

This range hood requires two 40-Watt light
bulbs (included).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Remove the screw securing the light fitting.
2. Pull down lens to remove.
3. Replace with light bulbs of the same type.

CAUTION: BULB MAY BE HOT!

fig.14

LIGHT

SWITCH

PILOT
LAMP

BLOWER

SWITCH

0 1

0 1 2 3 4

aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa

fig.15

fig.16

This manual is related to the following products:

NP503004