National Instruments 700 User Manual

Page 63

Index

© National Instruments Corporation

Index-3

DAQCard-700 User Manual

input configurations, 3-5 to 3-7

DIFF

definition (table), 2-4
purpose, 2-4

differential mode, 3-6
instrumentation amplifier

illustration, 3-6
purpose, 3-6

recommended input configurations

(table), 3-7

RSE

definition (table), 2-4
purpose, 2-4

single-ended mode, 3-6

installation. See also configuration.

steps for installing DAQCard-700,

2-1 to 2-2

unpacking the DAQCard-700, 1-4

instrumentation amplifier

illustration, 3-6
purpose and use, 3-6

interrupt levels, C-2
I/O connector

exceeding maximum ratings

(warning), 3-1

pin assignments (illustration), 3-2

LabVIEW and LabWindows/CVI

application software, 1-2

management, power modes, D-1
manual. See documentation
measurement systems

floating, 3-5
ground-referenced, 3-5

memory, C-2 to C-3
multichannel (scanned) data

acquisition, 4-5

NI-DAQ driver software, 1-3

operation of DAQCard-700. See also theory

of operation.

problems with, C-1

OUT, GATE, and CLK signals for general-

purpose timing, 3-14 to 3-17

OUT0 signal, 3-3
OUT1 signal, 3-3
OUT1* signal, 3-3
OUT2 signal, 3-3

PC-LPM-16, compared with

DAQCard-700, B-1

PCMCIA

I/O channel interface circuitry, 4-2 to 4-3
questions and answers, C-1 to C-3

physical specifications, A-2
power connections, 3-13
power-management modes, D-1
power requirement for DAQCard-700, A-2
programming. See software programming

choices for DAQCard-700.

pulse and square wave generation, 3-15
pulse-width measurement, 3-15

referenced single-ended input. See RSE

input.

signal connections