Removing memory cards – Nortel Networks L110 User Manual
Page 31
19
Inserting Memory Cards
First Ste
p
s
Removing Memory Cards
Before opening the battery-chamber/memory card slot
cover, turn the camera off and confirm that the
power-on lamp and the monitor are off. Open the
battery-chamber/memory card slot cover and press the
card in (1) to partially eject the card. Remove the card
(2), being careful not to bend it.
B
Formatting Memory Cards
If the message at right is displayed, the memory card must be
formatted before use (
). Note that formatting permanently
deletes all images and other data on the memory card. Be sure to
make copies of any images you wish to keep before formatting the
memory card.
To format the memory card, use the multi selector to select
Yes and
press
k. To start formatting, choose
Format and press
k
.
• Do not turn the camera off or open the battery-chamber/memory card slot cover until formatting is complete.
• The first time you insert the memory cards used in other devices into the camera, be sure to
format them using this camera (
B
The Write Protect Switch
SD memory cards are equipped with a write protect switch.
Images cannot be saved or deleted and the memory card
cannot be formatted when this switch is in the “lock” position.
Unlock by sliding the switch to the “write” position.
B
Memory Cards
• Use only Secure Digital memory cards.
• Do not perform the following during formatting, while data
is being written to or deleted from the memory card, or during data transfer to a computer. Failure
to observe this precaution could result in the loss of data or in damage to the camera or memory
card:
- Insert or remove the card
- Remove the batteries
- Turn off the camera
- Disconnect the AC adapter
• Do not format the memory card using a computer.
• Do not disassemble or modify.
• Do not drop, bend, or expose to water or strong physical shocks.
• Do not touch the metal terminals with your fingers or metal objects.
• Do not affix labels or stickers to the memory card.
• Do not leave in direct sunlight, closed vehicles or areas exposed to high temperatures.
• Do not expose to humidity, dust, or to corrosive gases.
1 2
Card is not formatted.
Format card?
No
Yes
Write protect switch