Nortel Networks Accelar 1050 - Manual (Page 43)

Appendix A Technical specifications 43
Nortel VPN Router Installation — VPN Router 1010/1050/1100
• 10BASE-T connections can use Category 3, 4, or 5 twisted-pair wiring.
Table 14 provides the 10/100BASE-TX Ethernet port pinouts for the system ports
on the VPN Router 1100.
Serial port
The system board provides a serial port on the front of the VPN Router 1010,
1050, and 1100 to enable out-of-band management of the gateway. The serial
cable provided with the VPN Router 1010, 1050, and 1100 is an RJ-45-to-DB9
cable (
Figure 15 on page 44 ). The RJ-45 connector goes into the VPN Router
1010, 1050, or 1100, and the DB9 connector goes into your workstation.
Table 14 10/100BASE-TX Ethernet port pinouts
Pin Description
1 TX +
2 TX -
3 RX +
6 RX -
Caution: Use this cable to connect a PC or modem to the VPN Router
1010/1050/1100. Do not use this cable to attach a PC or modem to any
other VPN Router device.
CS260010A
TX+ TX- RX- RX+
12345678