Nortel Networks Accelar 1050 - Manual (Page 26)

26
Chapter 1 Hardware overview
NN46110-313 02.01
Connecting the power cord
You must order the power cord for the VPN Router 1010/1050/1100 separately.
The power cord must meet the requirements described in
Table 2 .
To connect the power cord and turn on the power:
1 Plug the power cord into the AC receptacle on the external power supply
shipped with the VPN Router 1010/1050/1100.
Caution: Risk of equipment damage
Do not modify or use the AC power cord if it is not the exact type that is
required for your power outlet.
Table 2 Power cord requirements
Requirement Description
Current rating The power cord must be rated for the available AC voltage
and must have a current rating that is at least 125 percent of
the gateway’s current rating (1.5 A).
Certification The power cord must have certification marks from an
acceptable regional agency.
Cord length and flexibility The power cord must be less than 4.5 meters (14.7 feet) long.
It must be a flexible HAR (harmonized) cord or VDE-certified
cordage to comply with the gateway’s safety certifications.
Power supply connector The connector that you plug into the AC receptacle on the
gateway power supply must be an IEC 320, Sheet C5 female.
Wall outlet connector The power cord must terminate in a male plug with
appropriate grounding.
Caution: Before you connect the power supply to the gateway, connect
the cables to the Ethernet and serial ports. If you have a VPN Router
1100, also connect the cables to the ports on any installed option cards.