Nortel Networks Accelar 1050 - Manual (Page 37)

Chapter 2 Installing option cards in the Nortel VPN Router 1100 37
Nortel VPN Router Installation — VPN Router 1010/1050/1100
7 Remove the four screws on the sides of the VPN Router 1100.
8 Slide the chassis cover away from the base.
The VPN Router 1100 system board is now exposed. Figure 14 on page 37
shows the location of the option card slots on the system board.
9 Locate the slot where you plan to install the new or replacement option card
(
Table 11 on page 35 ).
Figure 14 VPN Router 1100 system board
Warning:
Risk of injury
Beware of danger if you incorrectly replace the battery. Replace the
battery with the same type or an equivalent battery only, as
recommended by the manufacturer’s instructions. In spite of this
warning, which is mandated for regulatory approval, you must not
change the battery. If you suspect a dead battery, contact Nortel
Customer Support.
10678FA
CPU
DIMM
Compact
flash
Option card
slots
Slot 3
Slot 2