Netopia 4752 - Manual (Page 75)

WAN and System Configuration 9-17
The ATMP/PPTP Default Profile
The ATMP/PPTP Default Profile screen controls whether or not your device will answer VPN connection attempts
without an explicitly configured connection profile. See
“Vir tual Private Networks (VPNs)” on page 12-1 for more
information.
System Configuration Screens
You can connect to the Netopia 4752’s system configuration screens in either of two ways:
■ By using Telnet with the device’s Ethernet por t IP address
■ Through the console por t, using a local terminal (see “Connecting a Console Cable to Your Device” on
page 6-3 )
You can also retrieve the Netopia 4752’s configuration information and remotely set its data routing
parameters using the Simple Network Management Protocol (see
“SNMP” on page 14-13 ).
Open a Telnet connection to the device’s IP address; for example, “192.168.1.1.”
The console screen will open to the Main Menu, similar to the screen shown below:
Navigating through the System Configuration screens
To help you find your way to par ticular screens, some sections in this guide begin with a graphical path guide
similar to the following example:
Netopia 4752 v5.1
Easy Setup...
WAN Configuration...
System Configuration...
Voice Configuration...
Utilities & Diagnostics...
Statistics & Logs...
Quick Menus...
Quick View...
Return/Enter goes to Easy Setup -- minimal configuration.
You always start from this main screen.