About ipsec tunnels, Configuration, About ipsec tunnels -7 – Netopia 4752 User Manual
Page 149: Configuration -7
Virtual Private Networks (VPNs) 12-7
The IP Profile Parameters screen appears.
■
Enter the Remote IP Address and Remote IP Mask for the host to which you want to tunnel.
About IPsec Tunnels
IPsec stands for IP Security, a set of protocols that suppor ts secure exchange of IP packets at the IP layer.
IPsec is deployed widely to implement Vir tual Private Networks (VPNs). See
for more
information.
IPsec suppor ts two encr yption modes: Transpor t and Tunnel. Transpor t mode encr ypts only the data por tion
(payload) of each packet, but leaves the header untouched. The more secure Tunnel mode encr ypts both the
header and the payload. On the receiving side, an IPsec-compliant device decr ypts each packet. Netopia
Routers suppor t the more secure Tunnel mode.
DES stands for Data Encr yption Standard, a popular symmetric-key encr yption method. DES uses a 56-bit key.
The Netopia 4752 offers IPsec DES encr yption over the VPN tunnel.
Configuration
IPsec tunnels are defined in the same manner as PPTP tunnels. You configure the Connection Profile as follows.
From the Main Menu navigate to WAN Configuration and then Add Connection Profile.
IP Profile Parameters
Address Translation Enabled: Yes
NAT Map List... Easy-PAT
NAT Server List... Easy-Servers
Local WAN IP Address: 0.0.0.0
Remote IP Address: 173.167.8.10
Remote IP Mask: 255.255.0.0
Filter Set...
Remove Filter Set
Receive RIP: Both
Enter a subnet mask in decimal and dot form (xxx.xxx.xxx.xxx).
Main
Menu
WAN
Configuration
Add Connection
Profile