Seat belt extenders -31, Warning – NISSAN CVT SIC0697 User Manual
Page 44
Attaching rear center seat belt
Always be sure the rear center seat belt connec-
tor tongue and connector buckle are attached.
Disconnect only when folding down the rear
seat.
To connect the buckle:
1. Pull out the connector tongue from the re-
tractor base
k
1
.
2. Pull out the seat belt tongue from the retrac-
tor base
k
2
.
3. Pull the seat belt and secure the connector
buckle until it clicks
k
3
.
The center seat belt connector tongue and
buckle are indicated by the “
̄” and “̆” mark.
The center seat belt connector tongue can be
attached only into the rear center seat belt
connector buckle.
To fasten the seat belt, see “Fastening the seat
belt” earlier in this section.
WARNING
¼ Do not unfasten the rear center seat
belt connector except when folding
down the rear seat.
¼ When attaching the rear center seat
belt connector, be certain that the
seatbacks are completely secured in
the latched position and the rear cen-
ter seat belt connector is completely
secured.
¼ If the rear center seat belt connector
and the seatbacks are not secured in
the correct position, serious personal
injury may result in an accident or
sudden stop.
Storing rear seat belt buckles
Before folding down the seat, put the buckles in
the storage of the seat cushion to avoid drop-
ping it under the seat cushion.
SEAT BELT EXTENDERS
If, because of body size or driving position, it is
not possible to properly fit the lap-shoulder belt
and fasten it, an extender is available. The ex-
tender adds approximately 8 inches (200 mm) of
length and may be used for either the driver or
front passenger seating position. See your
NISSAN dealer for assistance if the extender is
required.
SSS0235
Seats, restraints and supplemental air bag systems
1-31
੬
04.4.5/Z50-D/V5.0
੭