NISSAN CVT SIC0697 - Manual (Page 260)

Use the following steps to mount the license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the vinyl bag.
¼ License plate bracket
¼ Screw x 2
¼ Bolt grommet x 2
¼ Bolt x 2
1. Temporarily place the license plate bracket
while aligning points k
A of the front bumper
fascia with holes k
B in the license plate
bracket.
2. Remove the license plate bracket.
3. Carefully drill two pilot holes
k
A using a 0.39
in (10 mm) drill bit at the marked locations.
(Be sure that the drill only goes through
the fascia, or damage to the nut may
occur.)
4. Insert grommets into the hole on the fascia.
5. Install the license plate bracket with bolts.
6. Install the license plate with screws
k
C .
STI0340
INSTALLING FRONT LICENSE
PLATE
Technical and consumer information 9-13
੬ 04.4.5/Z50-D/V5.0 ੭