National Instruments DP8400 - Manual (Page 2)

Indicates that there is a 3
kX pull-up resistor on
these outputs when they
are disabled
TL F 5012 – 1
FIGURE 1 DP8409A Block Diagram
TABLE II DP8409A Mode Select Options
Mode
(RFSH)
M1 M0 Mode of Operation Conditions
M2
0 0 0 0 Externally Controlled Refresh RF I O e EOC
1 0 0 1 Auto Refresh Forced RF I O e Refresh Request (RFRQ)
2 0 1 0 Internal Auto Burst Refresh RF I O e EOC
3a 0 1 1 All RAS Auto Write RF I O e EOC
3b 0 1 1 Externally Controlled All RAS Access All RAS Active
4 1 0 0 Externally Controlled Access
5 1 0 1 Auto Access Slow t
RAH
Hidden Refresh
6 1 1 0 Auto Access Fast t RAH
7 1 1 1 Set End of Count
Modes 0 3b and 4 provide full control of access and re-
fresh for systems with external memory controllers or for
special purpose applications Here all timing can be directly
controlled by the external system as shown in
Figure 2
Modes 1 5 and 6 provide on-chip automatic access se-
quencing with hidden refresh capability A graphic example
of the automatic access modes of the DP8409A is shown in
Figure 3 All DRAM access timing and control is generated
from one input strobe RASIN no external clock is required
On-chip delays insure proper address and control sequenc-
ing once the valid parallel address is presented to the fall-
through input latches of the DP8409A When the RASIN
transitions high-to-low the decoded RAS output transitions
low strobing the row address into the DRAM array An on-
chip delay automatically generates a guaranteed selectable
(mode 5 or 6) row address hold time At this point the
DP8409A switches the address outputs from the row latch
to the column latch Then another on-chip delay generates
a guaranteed column address set-up time before CAS so
that the CAS output automatically strobes the column ad-
dress into the DRAM array Read or write cycles are con-
trolled by the system through independent control of the WE
buffer that is provided on-chip to minimize delay skewing
The automatic access mode makes the dynamic RAM ap-
pear static with respect to access timing In this mode only
one signal RASIN is needed after valid parallel addresses
are presented to the DP8409A to initiate proper access se-
quencing Access timing (RASIN to CAS) with full output
loading of 88 DRAMs in the auto access mode is deter-
mined by the dash number given on the DP8409A data
sheet All performance characteristics are specified over the
full operating temperature and supply ranges
2