Newcon Optik LRF MOD 4EC - Manual (Page 19)

16
Note: On a special request a menu of a particular unit can be
simplified to show only required modes.
Setup mode
To modify the Ready to Measure mode parameters:
ƒ
Enter the Setup mode.
With word Ready on the display press the M button till
display name
COdE is displayed and press the A button.
ƒ Select the desired parameter modification (see table below).
Press the M button till the code name of the desired
parameter is displayed and press A button.
To leave the Setup mode without changing measurement
parameters press and hold the M button for two seconds. This
works like the computer Esc key. The rangefinder will then keep
the last set of parameters and return to the Ready to Measure
mode.
Mode
Display name Dis
tance
Sp
eed
Azimuth Elev
ation
Retic
le
Targe
t
selection logic
Ready to
Measure
Ready As set at previous session
Standard1 Std 1
m Deg Deg -¦- Auto
Standard2 Std 2
m Mils Mils -¦- Auto