Newcon Optik LRF MOD 4EC User Manual

Page 17

2. In what units result of distance measurement is displayed:

meters or yards, degrees or mils, km/h or mph,

3. What reticle shape is visible: rectangular or crosshair, and
4. Which target is selected: first, last or most reflective (see the

Target selection logic (5.4) for more details).

The Setup mode is described in more detail below.
The unit has two standard sets of the Ready to Measure mode
parameters:

Standard1: distance is displayed in meters, azimuth and

elevation are displayed in degrees, crosshair reticle is
visible, auto target selection is used,

Standard2: distance is displayed in meters, azimuth and

elevation are displayed in mils, crosshair reticle is visible,
auto target selection is used,

Code 8 sets the same set of measurement parameters as the

Standard1, except for distance measurement in yards.

At start the unit assumes the Ready to Measure mode with
measurement parameters inherited from the previous setup. At
manufacturing stage the unit is set up into Standard1 set of
measuring parameters.

Mode switching and tuning

Pressing the Mode (M) button in the Ready to Measure mode
switches the unit between modes of operation:

Ready to Measure – Ready (9, Fig. 2) is displayed