Panduit TDP46H - Manual (Page 53)

PANDUIT TDP4*H GMTDPH-MAN Page 3-27
Section 3: Configuration
3. When the printer has completed the reset process it will beep 3
times and the Default Setting Completed display will appear. At
this time the printer is in the default configuration.
4. To exit the Default Setting Mode, power the printer off and then
back on.
CLEAR NON-STANDARD PROTOCOL
The standard protocol codes used by the printer can be modified to accommodate the requirements of different
host systems. However, if the printer is to be used with a system that does not use the custom protocol codes,
they can be cleared and the default protocol codes reactivated. The default values are: STX = 7BH, ETX = 7DH,
ESC = 5EH, ENQ = 40H, NULL = 7EH, CAN = 21H and OFFLINE = 5DH.
DOWNLOAD USER DEFINED PROTOCOL CODES
The user can define a set of custom protocol codes and download them to the printer using the LD
command.
DEFAULT SETTING
COMPLETED
Displays the firmware during the initialization. V 0.5.00.03.00
INITIALIZING
To Clear Non-Standard protocol codes, DSW2-7 is placed in the On
position and the printer powered on while simultaneously pressing
the LINE and FEED keys.
The printer will emit one long beep at which time the LINE and
FEED keys should be released.
When the keys are released, the printer will replace the Alternate
protocol codes with the default values.
After the default setting is complete, the printer will emit two short
beeps indicating the process is complete.
To exit the mode, power the printer off and then back on.
ALT. PROTOCOL
DEFAULT COMPLETE
Displays the firmware during the initialization. V 0.5.00.03.00
INITIALIZING
To enter the User Download mode, DSW2-7 is placed in the on
position and the printer is powered on while simultaneously
pressing the LINE key. The printer will emit one long beep after
which the LINE key is released.
1. Set DSW2-7 Off to replace the Standard protocol codes or On
to replace the Alternate set of protocol codes.
USER DOWNLOAD
PRESS THE LINE KEY