Paradyne Dual DSU 7511 - Manual (Page 11)

11 7511-A2-GN10-10 January 1999
Installing the Network and DTE Cables
"
Procedure
To install the cables:
1. Note the location of the 7511 Dual DSU circuit cards in the carrier (Slots 1–8,
Slots 9–16, or all slots).
2. Connect network cables to the appropriate NIM and backplane connector
according to the following table.
Facing the rear of the carrier, connect a 50-pin network cable to . . .
The NIM on the left side for DSU As on
7511 cards in Slots 9–16. The NIM on the right side for DSU As on
7511 cards in Slots 1–8.
Connector P22 for DSU Bs on 7511
cards in Slots 9–16. Connector P21 for DSU Bs of 7511 cards
in Slots 1–8.
3. Connect a DTE cable to each of the V.35 connectors on the rear connector
plates. Connect the other end of each cable to its respective DTE interface.
The top V.35 connector of each rear connector plate is for DSU A on the 7511
card in that slot. The bottom V.35 connector is for DSU B.
97-15548
P26 P25
P22 P21
Slots 1 – 8
D SU A
Slots 9 – 16
D SU B
D SU A
D SU B
DSU A
DSU B
DSU A
DSU B
R J48T R J48T