Planet Technology GSW-2416SF - Manual (Page 24)

Figure 4-19 VLAN members Configuration screen
#
Notice:
Change VLAN settings for every time, you have to reboot the switch to apply new settings.
4.4.3.3 Set flowcontrol
This command allows configuring per port flow control function of GSW-2416SF. The correct usage is shown as below:
Set flo
[n]=1-24, n is the specific Port ID.
802.3x flow control is enabled on Full-Duplex mode or Backpressure is enabled on Half-Duplex mode.
control o
Defa
The configuring per port flow con
wcontrol [n] enable/disable
Enable –
Disable – No flow r backpressure function on no matter Full-Duplex or Half-Duplex mode.
ult setting: Enable
trol screen in Figure 4-20 appears.
Figure 4-20 Flow Control port Configuration screen
EM-GSW2416SFv1 - 24 -