Panasonic DLP PT-D3500U - Manual (Page 13)

13
LAN terminal (page 38)
This terminal is used to control the projector from
the PC. (10Base-T/100Base-TX compliant)
DVI-D IN terminal (page 20)
DVI-D signals are applied to this terminal. (24-pin
DVI connector)
RGB 2 input (RGB 2 IN) terminal (page 20)
A terminal to input RGB or YP
B P R signals (D-SUB
15-pin female).
RGB 1 input (RGB 1 IN) terminal (pages 19, 20)
A terminal to input RGB or YP
B P R signals (BNC).
S-VIDEO input terminal (page 19)
An input terminal for S-video signals
(MIN4-pin DIN).
This terminal complies with S1 signals and
automatically toggles between 16:9 and 4:3
according to the size of input signals.
VIDEO input terminal (page 19)
An input terminal for video signals. (RCA)
VIDEO audio input terminal
An audio input terminal for video input signals.
(RCA)
S-VIDEO audio input terminal
An audio input terminal for s-video input signals.
(RCA)
RGB2 audio input terminal
An audio input terminal for RGB2 input signals.
(M3 stereo mini jack)
RGB1 audio input terminal
An audio input terminal for RGB1 input signals.
(M3 stereo mini jack)
AUDIO OUT terminal
An audio output terminal for audio amplifier or
other devices. (M3 stereo mini jack)
DVI audio input terminal
An audio input terminal for DVI-D input signals.
(M3 stereo mini jack)
Serial input terminal (RS-232C) (pages 20, 39)
Use the RS232C serial terminal as an alternative
interface for controlling the projector from your PC
(D-SUB 9-pin female).
REMOTE2 IN terminal (page 41)
The user can remotely control the main unit by
using an external control circuit to this terminal
(D-SUB 9-pin female).
REMOTE1 lN terminal (page 16)
The main unit can be controlled with a wired
remote control cable (M3 stereo mini jack).
Side-mounted
connection terminals
LAN terminal (10Base-T/100Base-TX)
Connect LAN cable.
LAN 10/100 lamp (Yellow)
Lights up when 100Base-TX
connected.
LAN LINK/ACT lamp (Green)
Lights up when connected.
Flashes when receiving/sending
signals.