Philips DCB293 - Manual (Page 20)

21
9 Troubleshooting
Warning
Never remove the casing of this apparatus. ‡
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
Ensure that the AC power plug of the ‡
unit is connected properly.
Ensure that there is power at the AC
‡
outlet.
To save power, the unit switches to Eco
‡
Standby mode automatically after 15
minutes in standby mode.
No sound
Adjust the volume. ‡
No response from the unit
Disconnect and reconnect the AC power ‡
plug, then turn on the unit again.
No disc detected
Insert a disc. ‡
Check if the disc is inserted with the print ‡
side facing inward.
Wait until the moisture condensation at
‡
the lens has cleared.
Replace or clean the disc.
‡
8VHDÀQDOL]HG&'RUFRUUHFWIRUPDWGLVF ‡
Maintenance
Clean the cabinet
Use a soft cloth slightly moistened with ‡
a mild detergent solution. Do not use
a solution containing alcohol, spirits,
ammonia or abrasives.
Clean discs
When a disc becomes ‡
dirty, clean it with a
cleaning cloth. Wipe the
disc from the centre out.
Do not use solvents
‡
such as benzene, thinner,
commercially available
cleaners, or antistatic spray intended for
analogue records.
Clean the disc lens
After prolonged use, dirt or dust may ‡
accumulate at the disc lens. To ensure
good play quality, clean the disc lens
with Philips CD lens cleaner or any
commercially available cleaner. Follow the
instructions supplied with cleaner.
English
EN