Pioneer KEH-P6020RB - Manual (Page 28)

07
Section
En 28
Audio Adjustments
Introduction of audio adjustments
1 AUDIO display
Shows the audio adjustments status.
2 LOUD indicator
Appears in the display when loudness is
turned on.
3 SW indicator
Appears in the display when subwoofer is
turned on.
4 F1 or F2 indicator
The F1 or F2 indicator lights depending on
the SFEQ setting.
5 CUSTOM indicator
Appears in the display when equalization is
adjusted.
Press AUDIO to display the audio function
names.
Press
AUDIO repeatedly to switch between the
following audio functions:
FADER (balance adjustment)— EQ (equalizer
curve fine adjustment)— BASS (bass)— TRE
(treble)— LOUD (loudness)— SUB.W (subwoofer
output)— 80HZ0 (subwoofer setting
adjustment)— SLA (source level adjustment)
• When selecting the FM tuner as the source,
you cannot switch to
SLA .
• To return to the display of each source, press
BAND/ESC .
Notes
• If you do not operate the audio function within
about 30 seconds, the display is automatically
returned to the source display.
• Audio Menu functions change depending on
the rear output setting in the Initial Setting
Menu. Refer to Switching the rear output set-
ting on page 36.
1
2 3 5
4