Pioneer KEH-P6020RB - Manual (Page 32)

Audio Adjustments
Adjusting treble
You can adjust the cut-off frequency and the
Treble level.
In
FRT1 and FRT2 modes, treble adjustment
affects only the front output: rear output cannot
be adjusted.
1 Press AUDIO to select TRE .
Press AUDIO until TRE appears in the display.
2 Select the desired frequency with
2/3.
Press
2 or 3 until the desired frequency
appears in the display.
2K — 4K — 6K — 10K (Hz)
3 Press
5 or ∞ to adjust the treble level.
Each press of
5 or ∞ increases or decreases
the treble level. +6 – –6 displayed as the level is
increased or decreased.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO to select LOUD .
Press AUDIO until LOUD appears in the display.
2 Press
5 to turn loudness on.
Loudness level (e.g., LOUD :MID ) appears in the
display.
3 Press
2 or 3 to select the level.
Press
2 or 3 until the desired level appears in
the display.
LOW (low)— MID (mid)— HI (high)
4 Press
∞ to turn loudness off.
LOUD :OFF appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to the rear output, first,
switch the rear output setting to subwoofer,
then turn the subwoofer output on. For more
details, see Switching the rear output setting on
page 36.
1 Press AUDIO to select SUB.W .
When the rear output setting is subwoofer, you
can select
SUB.W . Press AUDIO until SUB.W
appears in the display.
2 Press
5 to turn subwoofer output on.
SUB.W :ON appears in the display. Subwoofer
output is now on.
3 Press
∞ to turn subwoofer output off.
SUB.W :OFF appears in the display. Subwoofer
output is now off.
En 32
07
Section