Pioneer KEH-P6020RB - Manual (Page 31)

Audio Adjustments
En 31
Equalizer curve fine adjustment
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (
EQ-LOW/EQ-MID/EQ-
HIGH ).
1 Press AUDIO and hold until frequency and
the Q factor (e.g., F-80 Q-1W ) appears in the
display.
2 Press AUDIO to select the desired band for
adjustment.
Press
AUDIO repeatedly to switch between the
following bands:
EQ-LOW (low)— EQ-MID (mid)— EQ-HIGH (high)
3 Press
2/3 to select the desired frequency.
Press
2 or 3 until the desired frequency
appears in the display.
LOW: 40 — 80 — 100 — 160 (Hz)
MID: 200 — 500 — 1K — 2K (Hz)
HIGH: 3K — 8K — 10K — 12K (Hz)
4 Press
5/∞ to select the desired Q factor.
Press
5 or ∞ until the desired Q factor appears
in the display.
2N — 1N — 1W — 2W
Note
• If you make adjustments when a curve other
than CUSTOM2 is selected, CUSTOM1 curve
is updated.
Adjusting bass
You can adjust the cut-off frequency and the
bass level.
In
FRT1 mode, bass adjustment affects only the
rear output: front output cannot be adjusted.
1 Press AUDIO to select BASS .
Press AUDIO until BASS appears in the display.
2 Select the desired frequency with
2/3.
Press
2 or 3 until the desired frequency
appears in the display.
40 — 63 — 100 — 160 (Hz)
3 Press
5 or ∞ to adjust the bass level.
Each press of
5 or ∞ increases or decreases
the bass level. +6 – –6 displayed as the level is
increased or decreased.
Level (dB)
Q=2W Q=2N
Center frequency Frequency (Hz)
English
Español
Deutsch
F
rançais
Italiano
Nederlands
07
Section