Polaroid Digital Microscope Camera - Manual (Page 23)

Setting up 19
If the DMC camera is the only external SCSI device being
used with your computer, turn off the computer and the
camera. Then connect the SCSI cable provided to the
computer’s SCSI port (a). The port is marked with a SCSI
symbol for easy identification. If you have not already done
so, connect the other end of the SCSI cable (b) to the
camera’s SCSI connector as shown on page 13.
1scsimac.
Use only the SCSI cable provided with the camera. Other
cables may appear similar, but could damage the camera or
your computer. If you are using an Apple PowerBook
computer, read the special instructions on page 21 before
continuing.
After connecting the SCSI cable, connect the camera to AC
power using the power adapter (c).
IMPORTANT: ALWAYS CONNECT THE CAMERA TO
AC POWER WHEN IT IS CONNECTED TO THE
COMPUTER. IF THE CAMERA OR ANY OTHER SCSI
DEVICE TURNS OFF WHILE CONNECTED, IT COULD
CORRUPT DATA ON YOUR HARD DISK.
WHEN DISCONNECTING THE CAMERA, ALWAYS
DISCONNECT THE SCSI CABLE FROM THE BACK OF
THE COMPUTER BEFORE RESTARTING THE
COMPUTER. FAILURE TO DO SO COULD CORRUPT
DATA ON YOUR HARD DISK.
If the DMC is the only
SCSI device