Polaroid Digital Microscope Camera - Manual (Page 20)

16
Note: If a cable or adapter you need is not included with the
DMC camera, Polaroid Technical Assistance (see page 4) can
provide instructions for obtaining it.
IMPORTANT: Always connect the camera to AC power
when it is connected to the computer. If the camera or any
other SCSI device turns off while connected, it could corrupt
data on your hard disk.
Installing the DMC software on your PC
To operate the DMC camera, you must use one of the
following programs on your PC. Both are provided with the
DMC camera and are installed during the procedure given
below.
· DMC TWAIN driver Using the TWAIN driver requires an
image-processing application (not provided) compatible with
the TWAIN specification.
· DMC Direct software If you do not have an image-
processing application compatible with TWAIN, you can use
DMC Direct to transfer pictures from the DMC to your
computer.
To install the DMC software:
1 Turn on the computer and start the Windows program.
2 Insert the DMC for Windows diskette or CD-ROM into the
drive.
3 Click the Windows 95 Start button and choose Run.
4 Type a:\setup (or b:\setup if the diskette is in drive B) and
click OK.
5 Follow instructions on the screen to complete the
installation.
6 When an on-screen message indicates that installation has
been completed, click OK.