Panasonic AJ-D450 - Manual (Page 18)

– 18 –
Internal encoder adjustments
In order to ensure error-free and accurate editing during AB roll editing (a method of editing using two source
VTRs) using an editor, the ENCODER OUT controls must be adjusted after the system has been connected.
(These controls must be re-adjusted each time the connecting cables are replaced or the connections are
changed.)
Connect the equipment as shown in the figure below.
If a waveform monitor and vectorscope are not available, correct any color shifting while actually monitoring the
picture on the TV monitor.
Make these three
cables equally long.
The external reference signal is
supplied from the sync signal
generator to the equipment.
Composite connections apply
for the video signals.
VIDEO 1
OUT VIDEO 1
OUT VIDEO IN
REF (BB)
P1 IN P2 IN
REF IN RECORDER OUT
MONITOR OUT
75
Ω
Switcher
TV
monitor
WFM
(waveform
monitor)
VSC
(vectorscope)
P1 (AJ-D440) P2 (AJ-D440) Recorder (AJ-D750/AJ-D450)
REF
(BB)
REF
VIDEO IN
REF
(BB)
REF
VIDEO IN
REF
(BB)
Editing controller
(AG-A850)
REF
VIDEO IN
q
w
ON
OFF
POWER EJECT
REC PLAY FF STOP REW COUNTER/ REMAIN
RESET
CH CONDITION
LEVEL
HEADPHONES
CH 1 AUDIO REC LEVEL
CTL TC
UB
CH 1
MIX
CH 2
INT
EXT TC
AUDIO MONITOR DIGITAL
ANALOG Y PB PR CMPST S-VIDEO DIGITAL
AES/EBU
ANALOG REMOTE LOCAL
MENU
PAGE TC PRESET FILE
SET DIAG
VIDEO IN AUDIO IN CH 2