Power-on, Status leds – Paradyne 6310-A4 User Manual
Page 8
8
Power-On
When power is applied, the ReachDSL modem performs self-diagnostics and the PWR
LED is on. The self-diagnostics includes a power-on self-test and all of the LEDs turn on
for one second.
Status LEDs
All of the LEDs turn on and off during the power-on self-test. After a successful self-test,
the LEDs should appear as indicated in BOLD in the Condition column below.
Refer to
on page 9 for LED indications requiring action.
LED
Condition
Status
PWR
ON
ReachDSL modem has power.
ALM
OFF
ON
No active alarms.
An alarm condition exists.
TST
OFF
ON
No active tests.
The TST LED is on during the power-on self-test and
during a test initiated by the service provider.
LINE
ON
OFF
The DSL link is active and ready to transmit and receive
data.
The DSL link has not been established.
TX/RX
ON
OFF
Data transmission is in progress on the DSL line.
The modem is not transmitting or receiving data.
ETHERNET
ON
OFF
The Ethernet connection to the Ethernet hub or PC is
active.
No Ethernet 10BaseT device is detected.
ReachDSL
TST
LINE
ETHERNET
ALM
PWR
TX/RX
01-17003
Power – green
Alarm – red
Test – yellow
Transmit/Receive – green
Ethernet Link – green
DSL Line – green