Philips FW798W - Manual (Page 28)

28
English
Dubbing tapes (from tape deck 1 to
tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load the prerecorded tape into tape
deck 1 and a blank tape into tape deck
2.
™ Make sure that both tapes have their
full spool to the left.
3 Press SIDE on the remote control to
select the recording side.
4 Press DUB (HSD) once for normal
speed dubbing or twice (within 2
seconds) for high speed dubbing.
™ “NORMAL” (normal speed) or
“ FAST” (high speed) will be
displayed, followed by
“
DUBBING”.
™ The HSD flag appears on the display
during high speed dubbing.
• Dubbing will start immediately.
™ The REC flag starts flashing.
5 Press Ç to stop dubbing.
Notes:
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of
the same length.
– During high speed dubbing in Tape
mode, the sound is reduced to a low
volume.
– You can listen to another source while
dubbing.
RECORDING
CD Synchro Start Recording
1 Load a blank tape into tape deck 2 and a
disc into a disc tray.
2 Press CD to select CD mode.
• You can program the tracks in the order
you want them to be recorded (see
Programming Tracks). If you do not, the
tracks are recorded according to the
order on the selected disc.
3 Press REC to start recording.
™ The REC flag starts flashing.
• CD will start playback automatically.
4 Press Ç to stop recording.
One Touch Recording
• For One Touch Recording, as soon as you
press REC, the current source (CD,
TUNER or AUX) will be recorded on tape
deck 2.
1 Load a blank tape in tape deck 2.
2 Press REC to start recording.
™ The REC flag starts flashing.
3 Press Ç to stop recording.
Note:
– When you press RECORD while in TAPE
mode, "SELECT SOURCE" will be
displayed. One Touch Recording is not
possible in TAPE mode.
Digital Recording via Digital
Out
For CD digital recording, please refer to the
Instructions Manual of the CD Recorder,
digital audio equipment, etc.